KRIPPLED ANCHOVY Rigging Krippled Anchovy (4 to 6 inch Baitfish) |
||||
To bait Krippled Anchovy, slide plastic head up leader approx. 6 inches away from hook(s). Pull red plastic pin from holes in the head. Insert bait snugly into plastic head cavity, back of bait must be on the same side as the leader exit hole on nose. With bait forced tight up into head cavity. Hold red pin by ball end and insert pin point in round hole. Push pin straight down through bait and out lower hole. Fig.1. To ease entry of pin in frozen bait make a dry run with a dry toothpick. Place sharp end of toothpick in round hole and force toothpick down through bait and out other side. Place red pin in hole made by toothpick Fig. 2. Push pin till snug and twist pin head to line up straight with leader. Fig.3.
|
||||
Setting Hook While supporting baitfish, insert hook into the side of the bait. Enter hook high on the baits side, where the silver meets the blue. Approx. 1 1/2 -2" up from end of tail. Fig.5. The shank of the hook should lie flat against bait. In the case of a tandem rig the rear hook should hand free at the tip of the tail. Fig.6.
Carefully curve the bait towards the hook side. Tail end must be curved in. Hold plastic head in one hand and carefully pull leader so as to take up the slack between blister and hook, this will place the needed curve in the bait. |
||||
|
||||
Threading New Leader |
||||
Thread end
of leader through rear blister, through red pin and oval hole. Point leader end to exit at
rear of head cavity, loop leader end around, and lead back into cavity and exit through
nose hole. Fig.9.
|
||||
Tips |
||||
|
||||
Home | Products | Where to Find | Fishing Tips
| About Us | Email Us Copyright © 1998 - 2004 |